How to Address High Bearing of bushing for Ball Mill in Summer
The main bearing of the ball mill is one of the important components of the ball mill, which has a significant impact on the operating efficiency of the ball mill. In the high temperature state of summer, the main bearings of the ball mill are prone to high temperatures of the bearing, and in severe cases, there may even be tile failure accidents, which not only affect the operation of the ball mill, but also the operation of the entire beneficiation plant. In this article, we will explore together how to solve the problem of high temperature of the main bearing and bushing of the ball mill.
1. Timely replace the lubricating oil of the ball mill
During the operation of the ball mill, the relative rotational friction between the hollow shaft and the bearing generates heat, causing the temperature of the main bearing to rise. Therefore, the friction can be reduced by replacing the lubricating oil, forming a uniform oil film on the bearing surface and avoiding the temperature rise of the main bearing. The oil film of lubricating oil is related to temperature changes and is greatly affected by temperature changes. During the ball mill inspection process, the lubricating oil status should be checked in a timely manner, and regular laboratory tests should be conducted. When the viscosity of the lubricating oil drops outside the allowable range, the lubricating oil should be replaced in a timely manner.
2. Adjust the cooling water and cooling device of the ball mill
The cooling of the ball mill is very important. The cooling water inside the main shaft bearing sleeve and the cooling water in the main bearing oil tank are the two main water sources for the main bearings of the ball mill. The temperature and quantity of the cooling water have a great impact on the temperature of the main bearings of the ball mill. When the temperature of the cooling water is low, the lubricating oil cools down quickly and the cooling effect is good. Increasing the flow rate of the cooling water will also reduce the temperature of the main bearing sleeve.
In actual production, it is necessary to pay attention to reducing the temperature of cooling water as much as possible, increasing the flow rate of cooling water, and timely cleaning the cooler, cooling water pipeline, and large tile water jacket to ensure sufficient heat exchange between cooling water and lubricating oil and increase cooling efficiency.
3. Improve the environmental conditions of the ball mill
The temperature of the ball mill itself is greatly affected by the surrounding environment. In summer, the ambient temperature is high, and the temperature of the ball mill bearings is also high. Therefore, the doors and windows of the factory building, the oil pump room, and the observation holes of the large bearings should be opened to improve the ventilation conditions of the environment where the ball mill is located, reduce the temperature of the lubricating oil, and thus lower the temperature of the main bearings and large bearings of the ball mill. In addition, if conditions permit, axial flow fans can be installed in the oil pump station to increase air circulation and reduce the temperature of lubricating oil. The temperature can also be reduced by adding spray water to the return and outlet pipes.
4. Increase the cooling area of the oil pump
The cooler inside the ball mill oil pump can be reselected, or a series of coolers can be used to increase the cooling area of the ball mill lubricating oil, improve the heat exchange effect of the ball mill lubricating oil, reduce the temperature of the lubricating oil supplied to the ball mill, and thus lower the temperature of the bearing.
The above are measures to improve the temperature of the main bearing and bushing of the ball mill in summer. In actual production, the situation is complex and variable. It is necessary to regularly check the working status of the ball mill and take timely adjustment measures to avoid faults caused by high summer temperatures and ensure stable and efficient operation of the ball mill.
2026 November 2nd Week Marginal Product Recommendation
Margianl LCB Plastic Clip Linear Bushings:
Made of high anti-wear material EPB13;
2.Maintenance-free, self lubricating;
3. Chemical resistant;
4. Dust resistant and quit running;
5. Installation by force fitting;
6. The E10 inner tolerance ensues only after the press fit.






































