Have you ever met these common bearing damage?
Common Bearing Damage :1) The raceway surface and the roller are full of dents, particles on cage worn, grease (agent) is discolored. Usually this situation caused by unclean installation process.Keep it clean during installation, use new grease, check ...Read More >>
Sealed bearing --a better choice for Polluted using environment
If the bearing is used in a polluted environment, installation position of should be protected. The usual approach to designIn sealed Marginal Bearing structure, dirt cannot reach position. pollution level serious, you can use grease seal or shaft ...Read More >>
Advantages of MG-CR Filament wound plastic self-lubricating bearings used in isolating switches
The MG-CR Filament wound plastic self-lubricating bearings in Margingal Bearing is suitable for the mechanical rotating parts of indoor and outdoor high-voltage isolating switches with a rated voltage 40.5KV～252KV, ensuring that ...Read More >>
Capabilty Analysis and Testing Method of a Sliding Bearing
When we are using sliding bearings, if find that the temperature is very high, should stop operation of equipment quickly, out reason, and deal with it according to solutions provided above, but may be due different causes bearing heat. Therefore, solution ...Read More >>
Chapter 1:Capabilty Analysis and Testing Method of a Sliding Bearing
Sliding bearing is one of the important parts construction machinery. Poor installation will affect its performance and even cause failure machinery equipment. After installed, if alignment not carried out carefully, may XXX to suffer ...Read More >>
How properly install an oil-free bearings ?
Marginal Bearing introduces the precautions when installing oil-free bearings.1. It should be determined whether there are bumps, protrusions, etc. on mating surfaces of shaft and shell2. Whether is dust or mold sand attached to surface bearing shell.3. ...Read More >>